Use the 'format fs=fat32 quick' command to format it as FAT32, using the Quick (fast) routine.Use the 'assign' command to assign a drive letter to the USB drive - it will show up as a drive under My Computer.Ĭopy the extracted contents of the Windows 10 ISO to the USB driveĬopy the extracted contents of the Windows 10 ISO to the USB driveprobably didn't work for you as I'm guessing your key was already formatted NTFS. Use the 'select partition 1' command to select that partition.Use the 'active' command to make said partition active. Use the 'create partition primary' command to create a primary partition on the USB drive. If you dont have a Windows 7 or newer computer, download the 64-bit CloudReady image below to your Downloads folder (not. Use the 'select disk X' command to select the USB drive - 'X' is the disk number of your USB drive, and it is shown in the first column.Use the 'clean' command to erase everything on the USB drive. Use the 'list disk' command to display the list of storage drives - it will reveal all the HDDs, SSDs, USB drives, and so on, that are attached to your PC.Identify the disk number of the USB drive that you are using - you can easily find it by looking at the size column it is usually the last one that is listed.

Accept the UAC prompt, if asked, to continue. Use the 'diskpart' command to open the disk partitioning software.

To do this, open Run (Windows key + R will do the trick alternatively, it can be found in the Start menu), type 'cmd' and then press the OK button. Plug in the USB drive and follow the next steps to create the installation media:

I don't think just copying the contents of the ISO to a USB drive will work. Bring Windows 10 Iso file extract it and copy all the files of the SOURCES folder except INSTALL.WIM or INSTALL.ESD, then copy and replace the files in.

Windows 10 education install from usb